Please note that you must possess a current users permit issued by the BATFE in order to purchase this item.
The Twiggy Igniter is designed for those "F" and "G" class Single Use or RMS motors. Its unique oval shape and the 22-gauge wire allows for insertion through the smaller nozzles to bottom out into the "C slot" grain geometry found in these engines. Approximate measurements: 1/2 inch long and 1/8 inch OD (.125) at the widest point. The thickness of the oval is approximately 3/32 inch (or .093) with 15-inch leads. Using 12 volts, these high energy igniters will burst into flames with rapid combustion, similar to a sparkler, and burn at about 1,600degrees F. They will reliably ignite sugar motors, composites, black powder or anything that will burn. Moisture and shock resistant. Twiggy igniters are most commonly used with club type 12 volt Launch Controls. Usually three can be clustered at once, ground test to be sure your launch control is up to the task.
This ignition product is classified as UN0454, Igniters, Class 1.4s Which means that it does not require expensive Haz-Mat fees. This product can be shipped USPS "Surface Mail Only" under an existing USPS "Letter of Authority".